Nemokamas pristatymas

Pasaulyje pristatymas

Aukščiausios kokybės

Dovanos

Paramos 24/7

100% Moneyback

Grįžti Keistis

JETUNIT premium motociklo Uždegimo Ritė MZ SIMSON 6 V 12V dalis

JETUNIT premium motociklo Uždegimo Ritė MZ SIMSON 6 V 12V dalis

lizdo

    €15.55 €18.30
    • (4)

SKU: n138413

Žymos: nintendo maitinimo jungiklis, 6 v ritė, simson s70, simson, kristalų lempos, pwm rc, užrakto kaištis, s50 simson, mz, lenktynių uždegimo ritė motociklas.

Specifikacija:

  • Modelio Pavadinimas: JX-4046
  • Kilmės: KN(Kilmės)
  • Prekės Svoris: 0.4kg
  • Elemento Plotis: 0inch
  • Prekės Skersmuo: 0inch
  • Dydis: Standartinis dydis
  • Veiklos: Aukštos Kokybės
  • Pakuotė: popieriaus langelį
  • Išorės Bandymų, Sertifikavimo: ISO9001
  • Prekės Pavadinimas: jetunit
  • Elemento Aukštis: 0inch
  • sąlyga: Naujas

JETUNIT 100% premium motociklo Uždegimo Ritė MZ SIMSON 6 V 12V dalis

Aukštos kokybės Digtial Uždegimo Ritė oem kokybės atsarginių dalių didelį atsparumą trikdžiams Programos: MZ ir SIMSON 6 V arba 12 V (uždegimo ritė Čia yra 6 V ir 12 V galite pasirinkti, prašome parašyti, ką norite jūsų žinutę.Šis punktas gali tikti ir kitiems metams, markių ir modelių nei nurodytas aukščiau.Pasiteiraukite pardavėjo, įsitikinkite, kad jis tinka jūsų metai ir modelis PRIEŠ PERKANT.Kiekviena Pakuotė:1x uždegimo ritė

Yalahow94

    5
2020-10-09

Looks ok. Have not tested jet.

Ayorcugi

    4
2021-01-10

Item received, despite everything!

Evchenk76

    5
2020-08-26

a falta de probar

Yiyao Eshev0181k

    5
2020-12-15

Three coils have been tested and work satisfactorily, however the connections to the terminals are very poor and are likely to cause unreliability problems in regular use. Picture is attached. The enamelled wires from the primary winding emerge from the coil by the threaded terminal posts, and have some enamel removed from the copper before winding a couple of turns around the posts. A flat tear-shaped cover is put over this before the connection to external wiring is made. There is no clamping or pressure on these enamel wires, and considering a nominal 4A current, the resistance of the joint will be significant and is sure to lead to reduced performance. These wires should be welded, soldered or properly clamped in some way to give acceptable reliability. I only hope the internal quality of these coils is much better than this.

Jums taip pat patiktų